7 Steps To Install Your New Toilet Seat

plumbing


7 Steps To Install Your New Toilet Seat

By Yazmin Grimes 3 years ago plumbing

Have you moved to a new home and want to replace the broken toilet with a new toilet seat? The easiest way is DIY. If you want a new toilet, use the hardware included in the box of the new toilet seat by removing the old seat to place the new seat. You can face some problems with the old bolt stuck.

About one person spends more than an hour in the toilet every week, so make sure you're clean enough to securely fasten the seat. In this blog, we are going to discuss steps given by professional plumbers that you can use to install your new toilet seat. You can follow one after another to easily install a new toilet seat. 

There are Seven Steps You Can Install Your New Toilet Seat With the Help of Plumber:

Step 1:

Most toilet seat configurations may be the same from one toilet to another, being the standard common. Remember to read the installation instructions before removing the packaging of a new toilet seat. You have all the necessary tools available to start the project and start to replace the seat after you finish switching the seat.

Step 2:

We all know that toilet seats can be full of bacteria. So clean the existing toilet seat before replacing it. You must have a clean workspace to replace the toilet seat in an easy way. Lastly, if you have a sensitivity to dust, a mask may be useful when doing a home improvement project.

Step 3:

Most home toilets have two metal or plastic bolts on the back of the seat. The nut can hold the seat securely in place by the bolt fitting through the hole in the toilet. Check the top of the bolt before removing the old seat. If both bolts are on here, it could be a throat. You should be able to lift the old seat off the toilet by unscrewing the nuts from both sides of the bowl.

Step 4:

Typically, insert bolts to hold the seat to the toilet through the two holes in the toilet seat. Before installing the seat, then set it upright by placing it on top of your toilet and check which hole aligns best.

Step 5:

A new toilet seat that has been realigned can be slid into place by the included bolts. Put both bolts straight through the holes around the seat before tightening the bolts and nuts. Make sure the bolt fits snugly by the hole, and check the alignment of the seat. Adjust the toilet seat carefully until the bolt fits snugly.

Step 6:

Do not expose the bolt head completely to it. A plastic cover that hides the bolts is probably in your new toilet seat. These covers can usually slide easily over the bolts of some tool or effort. So to avoid deforming the cap fittings, the covers can be lined up before attempting to secure them.

Step 7:

The new toilet seat can be dismantled at any time, and don't forget to test its speed. If the hinges test and then close, you can open the seat. The toddy seat moves side to side, so the bolt will need to be re-tightened. Using it can also loosen your seat. You may need to adjust and tighten it regularly. 

Do you have a clogged toilet, leaky pipe, or other plumbing issue? Toilet plumbers are available to help! You can get a team of licensed plumbers to come to your home and fix the problem. 



Comments

There are no comments yet.
Authentication required

You must log in to post a comment.

Log in

Share

Tags